Panasonic PT-FX500

Chapter 4 Settings — [PROJECTOR SETUP] menu
96 - ENGLISH
[COMMAND]
Detailed settings of
[COMMAND]
Description
[INPUT]
[NETWORK] Switches the input to NETWORK.
[COMPUTER1] Switches the input to COMPUTER1.
[COMPUTER2] Switches the input to COMPUTER2.
[HDMI1] Switches the input to HDMI1.
[HDMI2] Switches the input to HDMI2.
[VIDEO] Switches the input to VIDEO.
[DIGITAL LINK] Switches the input to DIGITAL LINK.
[INPUT1] - [INPUT10]
*1
Switches the input to DIGITAL LINK, and switch the input of the
Panasonic twisted-pair-cable transmitter to the specied input.
[LAMP POWER]
[NORMAL] Sets the lamp brightness to high luminance.
[ECO] Sets the lamp brightness to low luminance.
[IN STANDBY MODE]
[OFF] Audio output is stopped during standby.
[ON] Audio is output during standby.
[VOLUME] [0] ~ [63] Sets the volume.
*1 When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected to the projector, its input
name is automatically reected from [INPUT1] to [INPUT10]. If an item where the input name is not reected is selected, it is disabled.
11) Press the <ENTER> button.
f
The command is xed and
n
is displayed at the left of the selected command.
12) Press asqw to select [STORE], and press the <ENTER> button.
Note
f
If you attempt to register the setting that would make the lamp turn on for a short time, an error message will be displayed on the screen. Set
the time and the command again.
f
To delete a command that has been already set, press the <DEFAULT> button on the remote control while the screen in Step 5) is
displayed, or select [DELETE] at the screen in Step 6) and press the <ENTER> button.
f
If multiple commands have been set for the same time, they are executed in chronological order starting from the smallest command
number.
f
The operating time will be the local time. (
x
page 96)
f
If an operation is executed with the remote control or the control panel of the projector or with a control command before the command set in
[SCHEDULE] is executed, the command set with the schedule function may not be executed.
[DATE AND TIME]
Set the time zone, date, and time of the built-in clock of the projector.
Setting the time zone
1) Press as to select [DATE AND TIME].
2) Press the <ENTER> button.
f
The [DATE AND TIME] screen is displayed.
3) Press as to select [TIME ZONE].
4) Press qw to switch [TIME ZONE].
Setting the date and time manually
1) Press as to select [DATE AND TIME].
2) Press the <ENTER> button.
f
The [DATE AND TIME] screen is displayed.
3) Press as to select [ADJUST CLOCK].
4) Press the <ENTER> button.
f
The [ADJUST CLOCK] screen is displayed.
5) Press as to select an item, and press qw to set the local date and time.
6) Press as to select [OK], and press the <ENTER> button.