ENGLISH - 73
f Refer to “Setting the remote control ID numbers” (x page 45) for how to set the ID number on the remote control.
[Factory default]
Return various setting values to their factory default settings.
1) Press as to select [Factory default].
2) Press the <ENTER> button.
f The [Return to Factory default?] screen is displayed.
3) Press as to select [Yes] and then press the <ENTER> button.
f The [OK?] screen is displayed.
4) Press as to select [Yes] and then press the <ENTER> button.
f The [Please wait] message will appear, and resetting operation will start, and after completing the operation, the
[Please wait] message will disappear.
Attention
f After executing the [Factory default], be sure to turn off the projector (x page 37), disconnect the power plug from the wall
outlet, and then turn on the projector in order to reect the initial setting values.
Note
f The PIN code, logo PIN code, [Logo select] setting, user logo, lamp usage time and lter usage time will not return to the
factory default settings even if [Factory default] is executed.
Chapter 4 Settings - [Expand] menu
To Next Page
Loading...
