3. Unscrew the 2 screws and remove the exhaust fan.
4. Unscrew the 3 screws fixing the power block (B/Q-Module
and P-Module).
5. Lift the power block, then unscrew the 1 screw and remove
the lamp connector terminal.
Note:
·
Because the lead wire between the power block and
the lamp connector terminal is short, be careful not
to apply excessive force into it.
6. Remove the power block.
7. Unscrew the 4 screws and separate the ballast unit and the
power unit.
8. Unscrew the 2 screws.
9. While pressing to shut each hook of the 2 resinous stands,
remove the B/Q-Module.
7.9. Removal of P-Module
1. Remove the power unit (P-Module block) according to the
steps 1 through 7 in the section 7.8. "Removal of B/Q-
Module".
2. Unscrew the 2 screws.
3. While pressing to shut each hook of the 2 resinous stands,
remove the P-Module.
16
PT-LB80NTU / PT-LB80NTE / PT-LB80NTEA / PT-LB80U / PT-LB80E / PT-LB80EA / PT-LB75NTU / PT-LB75NTE / PT-LB75NTEA / PT-LB75U / PT-LB75E / PT-LB75EA
To Next Page
Loading...
