8.4.5.1. Explanation of Buttons
Input Level Adjustment RGB:
Displays the RGB input level adjustment menu.
Model Info Setup
Displays the model information setup menu.
Exit:
Exits this application.
8.5. Flicker Adjustment
According to the procedure of chapter 5 "Flicker Adjustment Mode", minimize the flicker.
8.6. Input Level Adjustment
8.6.1. Adjustment Menu
8.6.2. Explanation of Buttons
OK:
Executes automatic sub contrast and sub brightness adjustments, then closes this dialog.
Cancel:
Cancels this menu.
8.6.3. Equipment to be used
PC, RGB Signal Generator, Software for Adjustment
8.6.4. Adjustment Procedure
1. Display Input Level Adjustment(RGB) menu.
2. Input a window pattern signal to COMPUTER 1 IN connector.
Note:
·
Use approx. 15 % window pattern as follows.
Black background (screen width) : White window width = 2 : 1
Black background (screen height) : White window height = 3 : 1
·
Use the window pattern of XGA (1 024 × 768).
3. Click the OK button.
8.7. Model Information Setup
Set the model information when the A-P.C.Board is replaced.
Note:
·
et the projector into standby mode (POWER indicator on the projector illuminated red), and execute the procedure in 8.7.4.
27
PT-LB80NTU / PT-LB80NTE / PT-LB80NTEA / PT-LB80U / PT-LB80E / PT-LB80EA / PT-LB75NTU / PT-LB75NTE / PT-LB75NTEA / PT-LB75U / PT-LB75E / PT-LB75EA
To Next Page
Loading...
