Panasonic PT-LW333

112 - ENGLISH
Ceiling mount bracket safeguards
f When installing the projector to a ceiling, be sure to use the specied optional Ceiling Mount Bracket for Projectors.
Model No.: ET-PKL100H (for high ceilings), ET-PKL100S (for low ceilings), ET-PKL420B (Projector Mount Bracket)
f When installing the projector, attach the drop-prevention kit included with the Ceiling Mount Bracket for Projectors.
f Ask a qualied technician to do the installation work such as mounting the projector on the ceiling.
f Panasonic takes no responsibility for any damage to the projector resulting from use of a ceiling mount bracket not
manufactured by Panasonic or the inappropriate choice of location for installation, even if the warranty period of the projector
has not expired.
f Unused products must be removed promptly by a qualied technician.
f Use a torque screwdriver or Allen torque wrench to tighten bolts to their specied tightening torques. Do not use electric
screwdrivers or impact screwdrivers.
f Read the Installation Instructions for the Ceiling Mount Bracket for Projectors for details.
f The model numbers of accessories and optional accessories are subject to change without prior notice.
Bottom View
Model No. of Ceiling mount bracket: ET-PKL100H (for high ceilings)
ET-PKL100S (for low ceilings)
ET-PKL420B (Projector mount bracket)
M4 × 0.7
10 mm (13/32")
Torque: M4 1.25 ± 0.2 N·m
Attention
f The above gure shows the attaching of the rubber cap to the xing screw hole of the ceiling mount bracket. Before installing
the ceiling mount bracket, remove the rubber cap rst and then attach the projector mount bracket.
f If the projector will be used for the desktop instead of for the ceiling, the rubber cap will be necessary to prevent burning.
Save it for future use.
f When ceiling mounting is not needed, please do not touch or remove the rubber cap in order to prevent burning.
Rubber cap
Chapter 7 Appendix - Ceiling mount bracket safeguards