Panasonic PT-LW333

ENGLISH - 83
f Use shielded LAN cable (STP cable) that is compatible with category 5 or above.
f Use a LAN cable with length of 100 m or shorter.
Projector settings
1) Use the LAN cable (Straight) to connect the projector with computer.
2) Turn on the projector.
3) Set the [Expand] menu → [Network] → [Network setting].
f For details, refer to the [Expand] menu → [Network] (x page 72).
Note
f Please conrm with your network administrator before you connect to an existing network.
f The following settings are set before the projector leaves the factory.
[DHCP]
Off
[IP address]
192.168.1.100
[Subnet]
255.255.255.0
[Gateway]
192.168.1.1
[DNS]
192.168.1.1
Computer setting
Connection can be made with wired LAN. However, conrm to your system administrator on network settings before chang-
ing any settings.
1) Turn on the computer.
2) Make the network setting according to your system administrator.
f If the projector settings are the default settings, the computer can be used with the following network settings.
[IP address]
192.168.1.101
[Subnet]
255.255.255.0
[Gateway]
192.168.1.1
When connecting via wireless LAN
The wireless module (Model No.: ET-WML100) of the optional accessories is required if you want to use the network function
through the wireless LAN.
f The wireless module can be connected via the wireless LAN to only the projector that the wireless module is attached.
Connection example
IEEE802.11b/g/n
Wireless module of optional accessories
(Model No.: ET-WML100)
Preparation and conrmation of the projector
1) Turn on the projector.
2) Insert the wireless module (Model No.: ET-WML100) of optional accessories firmly into the <USB A
(VIEWER/WIRELESS)> terminal.
Chapter 5 Operation of Function - Network connection