Panasonic PT-LW333

ENGLISH - 71
1) Press as to select [Ready Countdown].
2) Press the <ENTER> button.
3) Press as to switch the setting time.
f The items will switch each time you press the button.
[0 Min]
The ready mode of the power management function is continued.
[1 Min] ~ [30 Min]
From the ready mode of the power management function to the standby mode when the projector
reach the set time.
[Filter counter]
You can check and reset the lter usage time. And, you can set the cleaning cycle for the air lter.
1) Press as to select [Filter counter].
2) Press the <ENTER> button.
f The [Filter counter] screen is displayed.
3) Press as to switch the item.
f The items will switch each time you press the button.
[Filter counter]
Displays the using time of the lter.
[Timer]
Sets the time to display the warning icon.
[Filter counter
reset]
Resets the lter counter.
Setting [Timer]
If you want to clean the air lter periodically according to the operating environment, the lter warning icon [ ]
can be displayed on the projected screen.
1) Press as to select [Timer].
2) Press the <ENTER> button.
3) Press as to switch the setting of the time.
f The items will switch each time you press the button.
[Off] → [100 H] → [200 H] → [300 H]
[Filter counter reset]
1) Press as to select [Filter counter reset].
2) Press the <ENTER> button.
f The [Filter counter Reset?] screen is displayed.
3) Press as to select [Yes] and then press the <ENTER> button.
f The [OK?] screen is displayed.
4) Press as to select [Yes] and then press the <ENTER> button.
[Test pattern]
Displays the Test pattern built-in to the projector.
Settings of position, size, and other factors will not be reected in test patterns. Make sure to display the input signal before
performing various adjustments.
1) Press as to select [Test pattern].
2) Press the <ENTER> button.
f The [Test pattern] screen is displayed.
3) Press as to switch the item.
[Off]
Test pattern is not displayed.
Chapter 4 Settings - [Expand] menu