Panasonic PT-LX26HE

AUTO PC adjust
ENGLISH -
39
Settings
AUTO PC adjust
Select [PC adjust] from the Main Menu (see
“Navigating through the menu” on page 34),
then select the item from the sub-menu.
Remote Control
Control Panel
AUTO PC adj.
[Auto PC adjustment] function is provided to
automatically adjust [Fine sync], [Total dots],
[Horizontal] and [Vertical] positions to conform to your
computer.
Press ▲▼ to select [AUTO PC adj.] and
then press the <SELECT> button.
[Please wait...]
z
appears while the [Auto PC
adjustment] is in process.
To store adjustment parameters
The adjusted parameters from the [Auto PC
adjustment] can be stored in the projector. Once the
parameters are stored, the setting can be done just by
selecting a Mode (1–10) in the PC System Menu (see
page 38). See also [Store] on page 41.
Attention
[Fine sync], [Total dots], [Horizontal] and [Vertical]
z
position of some computers cannot be fully adjusted
with the [Auto PC adjustment] function. When the image
is not provided properly with this operation, manual
adjustments are required (
Æ
pages 40-41).
The [Auto PC adjustment] cannot be operated when
z
[480i], [576i], [480p], [576p], [720p], [1035i] or [1080i] is
selected in the PC System Menu (
Æ
page 38).