Panasonic PT-MW630

Chapter 4 Settings — [DISPLAY OPTION] menu
ENGLISH - 101
f Proceed to Step 5) when [USER] is selected.
5) Press as to select [DISPLAY DOTS], and press qw to match [DISPLAY DOTS] to the horizontal
resolution of the signal source.
6) Press as to select [MODE].
7) Press the <ENTER> button.
f Automatic adjustment is executed. [PROGRESS] is displayed while in automatic adjustment. When
completed, the screen returns to the [AUTO SETUP] screen.
Adjusting position automatically
1) Press as to select [AUTO SETUP].
2) Press the <ENTER> button.
f The [AUTO SETUP] screen is displayed.
3) Press as to select [POSITION ADJUST].
4) Press qw to switch the item.
[ON] Adjust the screen position and size when automatic setup is executed.
[OFF] Does not perform automatic adjustment.
Note
f The automatic setup function may not operate properly unless a still image containing clear blacks and whites is input.
[RGB IN]
Set the <RGB 1 IN> terminal and the <RGB 2 IN> terminal.
Switching the slice level of an input synchronization signal
1) Press as to select [RGB IN].
2) Press the <ENTER> button.
f The [RGB IN] screen is displayed.
3) Press as to select [SYNC SLICE LEVEL] for [RGB1] or [RGB2].
4) Press qw to switch the item.
[LOW] Set the slice level to [LOW].
[HIGH] Set the slice level to [HIGH].
Setting [EDID MODE] in [RGB IN] (RGB2 input)
1) Press as to select [RGB IN].
2) Press the <ENTER> button.
f The [RGB IN] screen is displayed.
3) Press asto select [EDID MODE] for [RGB2].
4) Press the <ENTER> button.
f The [EDID MODE] screen is displayed.
5) Press qw to switch the item.
f The items will switch each time you press the button.
[DEFAULT] Standard setting.
[SCREEN FIT] Changes the EDID data according to the [SCREEN FORMAT] setting.
[USER] Sets the [RESOLUTION] and [VERTICAL SCAN FREQUENCY] items as EDID.