Chapter 1āPreparation ā About your projector
32 - ENGLISH
r Connecting terminals
129 10 11 13 14 15
1 2 3 4 5 86 7
1 <DC OUT> terminal
This is the USB terminal only used for power supply. (DC 5 V,
maximum 2.0 A)
This can be used when the projector is in projecting status and
when power is to be supplied to the wireless display adapter,
etc.
2 <RGB 1 IN> terminals (<G/Y>, <B/P
B
>, <R/P
R
>, <SYNC/HD>,
<VD>)
This is a terminal to input the RGB signal or YC
B
C
R
/YP
B
P
R
signal.
3 <VIEWER/PAIRING> terminal
This is a terminal to connect the USB memory when using
the Memory Viewer function, pairing function, or data cloning
function. (x pages 185, 193)
4 <LAN> terminal
This is the LAN terminal to connect to the network.
This also supports the image transfer from the image transfer
application software. (x page 153)
5 <RGB 2 IN> terminal
This is a terminal to input the RGB signal or YC
B
C
R
/YP
B
P
R
signal.
6 <DIGITAL LINK/LAN> terminal
This is a terminal to connect a device that transmits video
signal or audio signal via the LAN terminal. Also, this is the LAN
terminal to connect to the network.
7 <VIDEO IN> terminal
This is a terminal to input video signal.
8 <HDMI 1 IN> terminal/<HDMI 2 IN> terminal
This is a terminal to input the HDMI signal.
9 <REMOTE 1 IN> terminal
This is a terminal to remotely control the projector using the
external control circuit.
10 <MONITOR OUT> terminal
This is a terminal to output the RGB signal or the YC
B
C
R
/
YP
B
P
R
signal input in the <RGB 1 IN> terminal or the <RGB 2
IN> terminal. When the input is switched to RGB1 or RGB2,
corresponding input signal is output.
11 <SERIAL IN> terminal
This is the RS-232C compatible terminal to externally control
the projector by connecting a computer.
12
<AUDIO IN 1> terminal/<AUDIO IN 2> terminal
This is a terminal to input audio.
This is a terminal to input audio signal. There are right input
<R> and left input <L>.
14 <VARIABLE AUDIO OUT> terminal
This is a terminal to output the audio signal input to the
projector.
15 <REMOTE 2 IN> terminal
This is a terminal to connect the remote control with a cable
when controlling the projector with a wired remote control.
Attention
f When a LAN cable is directly connected to the projector, the network connection must be made indoors.
The signal may deteriorate due to the effect of noise or cable length.
To Next Page
Loading...
