Panasonic PT-MW630

Chapter 4 Settings — [ADVANCED MENU] menu
ENGLISH - 95
[ADVANCED MENU] menu
On the menu screen, select [ADVANCED MENU] from the main menu, and select an item from the sub‑
menu.
Refer to “Navigating through the menu” (x page 79) for the operation of the menu screen.
[DIGITAL CINEMA REALITY]
You can increase the vertical resolution and enhance the picture quality by performing cinema processing when
the PAL (or SECAM) 576i signal, the NTSC 480i signal, and 1080/50i, 1080/60i are input.
1) Press as to select [DIGITAL CINEMA REALITY].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[AUTO] Automatically detects the signal and performs the cinema processing. (Factory default setting)
[OFF] Does not perform cinema processing.
[30p FIXED]
When 480i or 1080/60i signal
is input
Performs forced cinema processing (2:2 pulldown).
[25p FIXED]
When 576i or 1080/50i signal
is input
Note
f In [DIGITAL CINEMA REALITY], the picture quality will degrade when a signal other than the 2:2 pulldown is set as [25p FIXED] or [30p
FIXED]. (Vertical resolution will degrade.)
[BLANKING]
You can adjust the blanking width if there are noises at the edge of the screen or the image is slightly running out
from the screen while an image from the VCR or other devices are projected.
1) Press as to select [BLANKING].
2) Press the <ENTER> button.
f The [BLANKING] adjustment screen is displayed.
3) Press as to select [UPPER], [LOWER], [LEFT], or [RIGHT].
4) Press qw to adjust the blanking width.
Blanking correction Item Operation Adjustment Range of adjustment
Top of the screen [UPPER]
Press q.
The blanking zone
moves upward.
PT-MZ670, PT-MZ570: Top
and bottom 0 - 599
PT-MW630, PT-MW530: Top
and bottom 0 - 399
Press w.
The blanking zone
moves downward.
Bottom of the
screen
[LOWER]
Press w.
The blanking zone
moves upward.
Press q.
The blanking zone
moves downward.