Chapter 3 Basic Operations — Operating with the remote control
ENGLISH - 77
f The ID number set on the remote control will be stored unless it is set again. However, it will be erased if the remote control is left with dead
batteries. Set the same ID number again when the batteries are replaced.
Note
f When the ID number of the remote control is set to [0], the projectors can be controlled regardless of the ID number setting on the projector,
same as when set to [ALL].
f Set the ID number of the projector from the [PROJECTOR SETUP] menu → [PROJECTOR ID] (x page 112).
To Next Page
Loading...
