Panasonic PT-MZ11K

Chapter 5 Operations — Using the information monitor function
ENGLISH - 221
10) Press the <ENTER> button.
f Setting can be changed.
11) Press qw to switch the setting.
f The items will switch each time you press the button.
[ON] Select this item when the temporary IPv6 address is used.
[OFF] Select this item when the temporary IPv6 address is not used.
Note
f This setting item is common with the following menu item in the on-screen menu.
g The [NETWORK] menu → [WIRED LAN] → [IPv6 SETTINGS] → [TEMPORARY ADDRESS]
r Connecting via wireless LAN
Set the wireless LAN function.
f To use the wireless LAN function with the projector, it is necessary to attach the optional Wireless Module
(Model No.: AJ-WM50 Series) to the <USB> terminal.
1) Press as to select [SETUP].
2) Press the <ENTER> button.
f The sub-menu item is displayed.
3) Press as to select [NETWORK].
4) Press the <ENTER> button.
f The network selection item is displayed.
5) Press as to select [WIRELESS LAN].
6) Press the <ENTER> button.
f The current setting is displayed.
7) Press the <ENTER> button again.
f Setting can be changed.
8) Press qw to switch to [ENABLE].
f The items will switch each time you press the button.
[DISABLE] Select this item when the wireless LAN is not to be used.
[ENABLE] Select this item when the wireless LAN is to be used.
Note
f [WIRELESS LAN] cannot be set if the optional Wireless Module (Model No.: AJ-WM50 Series) is not installed in the <USB> terminal.
f This setting item is common with the following menu item in the on-screen menu.
g The [NETWORK] menu → [WIRELESS LAN]
[STATUS] menu
Display the status of the projector.
1) Press as to select [STATUS].
2) Press the <ENTER> button.
f The sub-menu item is displayed.
3) Press as to select an item.
Sub-menu item Overview
[PROJECTOR] Displays the information of the projector.
[INFO MONITOR] Displays the setting information of the information monitor.
[NETWORK] Displays the setting information of network.
[VERSION] Displays the rmware version of the projector.