Chapter 3 Basic Operations — Switching on/o the projector
66 - ENGLISH
Switching o the projector
1)
1)
2)
4)
3)
2)
1) Press the <STANDBY> button.
f The [POWER OFF(STANDBY)] conrmation screen is displayed.
2) Press qw to select [OK], and press the <ENTER> button.
(Or press the <STANDBY> button again.)
f Projection of the image will stop, and the power indicator <ON (G)/STANDBY (R)> on the projector body
lights orange. (The fan keeps running.)
3) Wait for a few seconds until the power indicator <ON (G)/STANDBY (R)> of the projector body lights/
blinks red.
4) Press the <OFF> side of the <MAIN POWER> switch to turn off the power.
Note
f For approximately ve seconds after the projector is turned o, the indicator does not light up even if the power is turned on.
f Even when the <STANDBY> button is pressed and the projector is switched o, the projector consumes power if the main power
of the projector is on.
Usage of some functions is restricted but the power consumption during the standby mode is conserved when the [PROJECTOR SETUP]
menu → [STANDBY MODE] is set to [ECO].
f While projecting, the power can be turned o by setting the <MAIN POWER> switch to <OFF>, or by directly using the breaker under
conditions where the <MAIN POWER> switch of the projector cannot be switched o/on easily such as while installing on the ceiling.
However, the settings or adjustments performed right before the power is turned o may not be reected.
To Next Page
Loading...
