Chapter 5 Operations — Using HDMI-CEC function
230 - ENGLISH
Menu operation of CEC-compatible device
When the setting menu of the CEC-compatible device is displayed, you can use the ▲▼◀▶buttons and
<ENTER> button of the remote control to operate the menu.
About the link control
By setting the [PROJECTOR SETUP] menu → [HDMI CEC] → [PROJECTOR -> DEVICE] / [DEVICE ->
PROJECTOR] to a setting other than [DISABLE], the following link operations can be achieved.
The link control setting of [PROJECTOR -> DEVICE]
r When the setting is [POWER OFF] or [POWER ON / OFF]
f If the projector is switched o, all connected CEC-compatible devices are switched o.
r When the setting is [POWER ON / OFF]
f When the projector is switched on and starts projection, the CEC-compatible devices connected to the <HDMI
IN 1> terminal or <HDMI IN 2> terminal are switched on upon startup of the projector.
The link control setting of [DEVICE -> PROJECTOR]
r When the setting is [POWER ON] or [POWER ON / OFF]
f While the projector is in standby, if the CEC-compatible device is turned on, the projector turns on and switches
to the input that the CEC-compatible device is connected.
f While the projector is in standby, if the CEC-compatible device starts playing, the projector turns on and
switches to the input that the CEC-compatible device is connected.
f While the projector is turned on, if the CEC-compatible device starts playing, the projector switches to the input
that the CEC-compatible device is connected.
r When the setting is [POWER ON / OFF]
f When the CEC-compatible device connected to the <HDMI IN 1> terminal or <HDMI IN 2> terminal is switched
o, the projector enters standby mode.
Note
f When [DEVICE -> PROJECTOR] menu is set to [POWER ON / OFF], power-on link control and power-o link control work only if it is
supported by the connected CEC-compatible device.
f Depending on the status of the device, such as when the projector or the CEC-compatible device is starting up, the link control may not
operate normally.
f If the CEC-compatible device does not support CEC 1.4, it may not support the link control described in the manual.
f Depending on the connected CEC-compatible device, the link control may not operate normally.
To Next Page
Loading...
