Panasonic PT-MZ11K

Chapter 6 Maintenance — Light source/temperature/lter indicators
ENGLISH - 239
Light source/temperature/lter indicators
When an indicator lights up
If a problem occurs inside the projector, the slight source indicator <LIGHT>/temperature indicator <TEMP>/lter
indicator <FILTER> will inform you by lighting or blinking. Check the status of the indicators and take following
measures.
Attention
f When switching o󰀨 the projector to deal with problems, make sure to follow the procedure in “Switching o󰀨 the projector” (x page 66).
Light source indicator <LIGHT>
Indicator status Status Solution
Lighting red
Some of the elements of the light
source are defective and the light
output has decreased.
f Turn the <MAIN POWER> switch to <OFF> (x page 66), and turn on the
power again.
Blinking red
(1 time)
The light source is turned o󰀨 since the
projection lens cannot be detected.
f Turn o󰀨 the power and mount the projection lens again. (x page 45)
f Turn the <MAIN POWER> switch to <OFF> (x page 66), and turn on the
power again.
Blinking red
(2 times)
The light source does not light up,
or the light source turns o󰀨 while the
projector is in use.
f Turn the <MAIN POWER> switch to <OFF> (x page 66), and turn on the
power again.
Blinking red
(3 times)
Note
f If the light source indicator <LIGHT> is still lit or blinking after taking the measures, set the <MAIN POWER> switch to <OFF>, and ask your
dealer for repairs.
Light source indicator <LIGHT>
Temperature indicator <TEMP>
Filter indicator <FILTER>