Panasonic PT-MZ11K

Chapter 3 Basic Operations — Operating with the remote control
76 - ENGLISH
Using the status function
Display the status of the projector.
button
1) Press the <STATUS> button.
f The [STATUS] screen is displayed.
10000h
10000h / 10000h
1/5
1.00
1h 23m
31°C/87°F
31°C/87°F
31°C/87°F
31°C/87°F
123456789012
MENU
EXITCHANGE
ENTER
SEND E-MAIL
SELF TEST
NO ERRORS
LIGHT2 TEMP.
LIGHT1 TEMP.
EXHAUST AIR TEMP.
INTAKE AIR TEMP.
FIRMWARE VERSION
CONTINUOUS LIGHTING TIME
LIGHT RUNTIME
PROJECTOR RUNTIME
PROJECTOR TYPE
STATUS
PT-MZ20K
SERIAL NUMBER
Note
f The projector status can also be displayed using the menu operation. Refer to the [PROJECTOR SETUP] menu → [STATUS]
(x page 146) for details.
Using the HDMI‑CEC function
Display the HDMI-CEC operation screen.
button
1) Press the <CEC> button.
f The HDMI-CEC operation screen is displayed.
Note
f Refer to [PROJECTOR SETUP] menu → [HDMI CEC] (x page 151) for details.
Setting ID number of the remote control
When you use the multiple projectors together, you can operate all the projectors simultaneously or each projector
individually using a single remote control, if a unique ID number is assigned to each projector.
After setting the ID number of the projector, set same ID number on the remote control.
The factory default ID number of the projector is set to [ALL]. When using a single projector, press the <ID
ALL> button on the remote control. Also, you can control a projector by pressing the <ID ALL> button on
the remote control even if you do not know the projector ID.
button button
1) Press the <ID SET> button on the remote control.
2) Within five seconds, press and set the one‑digit or two‑digit ID number set on the projector using the
number (<0> ‑ <9>) buttons.
f If you press the <ID ALL> button, you can control the projector regardless of the ID number setting of the
projector.
Attention
f Since the ID number of the remote control can be set without the projector body, do not press the <ID SET> button on the remote control
carelessly. If the <ID SET> button is pressed and no number (<0> - <9>) buttons are pressed within ve seconds, the ID number returns to
its original value before the <ID SET> button was pressed.