Panasonic PT-RZ12K

Chapter 3 Basic Operations — Operating with the remote control
ENGLISH - 73
Operating with the remote control
Switching the input
The input for projection can be switched. Method to switch the input is as follows.
f Press the input selection button and directly specify the input to project.
f Display the input selection screen and select the input to project from the list.
button
Switching the input directly
The input for projection can be switched by directly specifying it.
1) Press the input selection button (<RGB1>, <RGB2>, <VIDEO>, <S-VIDEO Y/C>, <DIGITAL LINK>,
<DVI-D>, <HDMI>, <SDI>).
f This operation can be also performed using the buttons on the control panel.
<RGB1>
<VIDEO>
<S-VIDEO Y/C>
Switches the input to RGB1.
<RGB2> Switches the input to RGB2.
<DIGITAL LINK> Switches the input to DIGITAL LINK.
<DVI-D> Switches the input to DVI-D.
<HDMI> Switches the input to HDMI.
<SDI>
Switches the input to SDI1 or SDI2. Switches to the other input when one input has already been
selected. Also, input selection can be xed to SDI1 or SDI2 using the [SECURITY] menu →
[CONTROL DEVICE SETUP].