Panasonic PT-RZ12K

Chapter 3 Basic Operations — Operating with the remote control
76 - ENGLISH
Using the function button
The <FUNCTION> button of the remote control can be used as a simplied shortcut button by assigning the
following functions: [P IN P], [SUB MEMORY], [SYSTEM SELECTOR], [SYSTEM DAYLIGHT VIEW], [FREEZE],
[WAVEFORM MONITOR], [LENS MEMORY LOAD], [LEFT/RIGHT SWAP], [PROJECTION METHOD]
button
1) Press the <FUNCTION> button.
Note
f Assignment of the function is performed from the [PROJECTOR SETUP] menu → [FUNCTION BUTTON] (x page 146).
Displaying internal test pattern
The projector has eight types of internal test patterns to check the condition of the projector body. To display test
patterns, perform the following steps.
button
1) Press the <TEST PATTERN> button.
2) Press qw to select the test pattern.
Note
f Setting is also available from the [TEST PATTERN] (x page 154) menu.
f Settings of position, size, and other factors will not be reected in test patterns. Make sure to display the input signal before performing
various adjustments.
Using the status function
Display the status of the projector.
button
1) Press the <STATUS> button.
f The [STATUS] screen is displayed.
100000h
100000h / 100000h
1.00 / 1.00
1/5
31°C/87°F
27°C/80°F
31°C/87°F
31°C/87°F
31°C/87°F
1013hPa
MENU
EXITCHANGE
ENTER
SEND E-MAIL
SELF TEST
ATMOSPHERIC PRESSURE
AUTO - FLOOR
NO ERRORS
COOLING CONDITION
AROUND LIGHT2 TEMP.
AROUND LIGHT1 TEMP.
EXHAUST AIR TEMP.
OPTICS MODULE TEMP.
INTAKE AIR TEMP.
MAIN/SUB VERSION
LIGHT RUNTIME
PROJECTOR RUNTIME
PROJECTOR TYPE
STATUS
RZ12K(123456789012)
Note
f This can be displayed from the [PROJECTOR SETUP] menu → [STATUS] (x page 148).