Panasonic PT-RZ12K

Chapter 4 Settings — [PROJECTOR SETUP] menu
142 - ENGLISH
f The zoom and focus positions may have shifted after lens memory was loaded. Readjust as necessary.
Beware of shift, as errors in zoom position are particularly signicant.
f When a lens is replaced, readjust and save the lens memory again.
f If a lens without zoom function is used, the lens memory of the zoom position does not operate.
f When [LENS MEMORY LOAD] is assigned to the <FUNCTION> button, the registered lens memory is loaded in order each time you press
the <FUNCTION> button.
Deleting a lens memory
1) Press as to select [LENS MEMORY].
2) Press the <ENTER> button.
3) Press as to select [LENS MEMORY EDIT].
4) Press the <ENTER> button.
f The [LENS MEMORY EDIT] screen is displayed.
5) Press as to select [LENS MEMORY DELETE].
6) Press the <ENTER> button.
f The [LENS MEMORY DELETE] screen is displayed.
7) Press as to select the item to delete, and press the <ENTER> button.
8) When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
Changing the lens memory name
1) Press as to select [LENS MEMORY].
2) Press the <ENTER> button.
3) Press as to select [LENS MEMORY EDIT].
4) Press the <ENTER> button.
f The [LENS MEMORY EDIT] screen is displayed.
5) Press as to select [LENS MEMORY NAME CHANGE].
6) Press the <ENTER> button.
f The [LENS MEMORY NAME CHANGE] screen is displayed.
7) Press as to select the name to change, and press the <ENTER> button.
f The [LENS MEMORY NAME INPUT] screen is displayed.
8) Press asqw to select the text, and press the <ENTER> button to enter the text.
9) After the name is changed, press asqw to select [OK], and press the <ENTER> button.
f The registration completes and returns to the [LENS MEMORY NAME CHANGE] screen.
f If you press asqw to select [CANCEL] and then press the <ENTER> button, the changed name will not
be registered.
f If you press asqw to select [DEFAULT] and press the <ENTER> button, the changed name will not be
registered and the default name will be used.
f If you select [OK] without entering any characters and press the <ENTER> button, the default name will be
used.
[STATUS]
Display the status of the projector.
1) Press as to select [STATUS].
2) Press the <ENTER> button.
f The [STATUS] screen is displayed.