Chapter 3 Basic Operations — Switching on/off the projector
ENGLISH - 63
Note
f When the projector is switched on for the rst time after purchase, as well as when [ALL USER DATA] is executed from the [PROJECTOR
SETUP] menu → [INITIALIZE], the focus adjustment screen is displayed after projection starts, then the [INITIAL SETTING] screen is
displayed. Refer to “When the initial setting screen is displayed” (x page 56) for details.
Switching off the projector
1)
2)
1)
4)
3)
2)
1) Press the power standby <v> button.
f The [POWER OFF(STANDBY)] conrmation screen is displayed.
2) Press qw to select [OK], and press the <ENTER> button.
(Or press the power standby <v> button again.)
f Projection of the image will stop, and the power indicator <ON (G)/STANDBY (R)> on the projector body
lights in orange. (The fan keeps running.)
3) Wait for a few seconds until the power indicator <ON (G)/STANDBY (R)> of the projector body lights
up in red (fan is stopped).
4) Press the <OFF> side of the <MAIN POWER> switch to turn off the power.
Attention
f When switching off the projector, make sure to follow the procedures described. Failure to do so may damage the internal components and
result in malfunctions.
Note
f For approximately 15 seconds after the projector is switched off, the indicator does not light up even if the power is switched on.
f Even when the power standby <v> button is pressed and the projector is switched off, the projector consumes power if the main
power of the projector is on.
When the [PROJECTOR SETUP] menu → [STANDBY MODE] is set to [ECO], use of some functions is restricted, but the power
consumption during standby can be conserved.
To Next Page
Loading...
