Panasonic PT-RZ12K

Chapter 4 Settings — [NETWORK] menu
176 - ENGLISH
Example of the E-mail sent for an error
The following E-mail is sent when an error has occurred.
=== Panasonic project or report (ERRO R) ===
Projector T ype : RZ12K
Serial No : 123456789012
----- check system -----
MAIN CPU BUS [ FAILED ]
FAN [ OK ]
INTAKE AIR TEMPERATURE [ OK ]
OPTICS MODULE TEMPERATURE [ OK ]
EXHAUST AIR TEMPERATURE [ OK ]
LD1 TEMPERATURE [ OK ]
LD2 TEMPERATURE [ OK ]
LD1 STATUS [ OK ]
LD2 STATUS [ OK ]
SHUTT ER(MUT E-SHUT T ER) [ O K ]
INTAKE AIR TEMP.SENSOR [ OK ]
OPTICS MODULE TEMP.SENSOR [ OK ]
EXHAUST AIR TEMP.SENSOR [ OK ]
LD1 TEMP.SENSOR [ OK ]
LD2 TEMP.SENSOR [ OK ]
POWER CIRCUIT T EMPERAT URE [ O K ]
FPGA TEMPERATURE [ OK ]
BATTERY [ OK ]
LENS MOUNT ER [ OK ]
BRIGHTNESS SENSOR [ OK ]
PHOSPHOR WHEEL1 [ OK ]
PHOSPHOR WHEEL2 [ OK ]
FILTER UNIT [ OK ]
AIR F ILTER [ OK ]
AC VOLTAGE [ OK ]
(Error code 80 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00)
Intake air temperature : 30 degC / 86 degF
O pt ics module t emperat ure : 39 degC / 102 degF
Exhaust air temperature : 32 degC / 89 degF
Around light1 t emperature : 34 degC / 93 degF
Around light2 t emperature : 34 degC / 93 degF
PROJECT O R RUNT I ME 77 H
POWER O N 1906 times
LD1-1 O N 1906 t imes
LD1-1 RUNT I ME 76 H
LD1-2 O N 1906 t imes
LD1-2 RUNT I ME 76 H
LD1-3 O N 1906 t imes
LD1-3 RUNT I ME 76 H
LD1-4 O N 1906 t imes
LD1-4 O N 1906 t imes
LD1-4 RUNT I ME 76 H
LD1-5 O N 1906 t imes
LD1-5 RUNT I ME 76 H
LD1-6 O N 1906 t imes
LD1-6 RUNT I ME 76 H
LD2-1 O N 1900 t imes
LD2-1 RUNT I ME 75 H
LD2-2 O N 1900 t imes
LD2-2 RUNT I ME 75 H
LD2-3 O N 1900 t imes
LD2-3 RUNT I ME 75 H
LD2-4 O N 1900 t imes
LD2-4 RUNT I ME 75 H
LD2-5 O N 1900 t imes
LD2-5 RUNT I ME 75 H
LD2-6 O N 1900 t imes
LD2-6 RUNT I ME 75 H
-------- Current status ---------
MAIN VERSION 0.24
SUB VERSION 0.04.01
LD STATUS
LD1-1=ON LD1-2=ON LD1-3=ON LD1-4=O F F LD1-5=OF F LD1-6=O N
LD2-1=ON LD2-2=ON LD2-3=ON LD2-4=O F F LD2-5=OF F LD2-6=O F F
INPUT SDI1
SIGNAL NAME ---
SIG NAL FREQ UENCY ---kHz / ---Hz
REMOTE2 STATUS DISABLE
----- Wired Network configuration -----
DHCP Client OFF
IP address 192.168.0. 8
MAC address 12: 34: 56: 78: 90: 12
Mon Jan 01 12: 34: 56 20XX
----- Memo -----