Replacement
ENGLISH -
61
Maintenance
J
Replacing the Lamp unit
CAUTION:
When the projector is mounted on a ceiling, do not work with your face close to the projector.
z
Attach the lamp unit and the lamp cover securely.
z
When you experience difculty in installing the lamp, remove it and try again. If you use force to install the
z
lamp, the connector may be damaged.
Turn off the Power by following the procedure 1 )
in "Turning Off the projector" (
Æ
page 27).
Unplug the AC power cord. Wait at least 1 hour
and make sure the lamp unit and
surroundings are cool.
Use a Phillips screwdriver to loosen the 2 )
lamp cover xing screw and remove the l
amp cover.
Remove the lamp cover by pulling it slowly
z
toward the direction of the arrow.
Use a Phillips screwdriver to loosen the 3 )
three lamp unit xing screws until the
screws turn freely. Hold the used lamp
unit by its handles, and pull it gently
from the projector.
Insert the new lamp unit in correct 4 )
direction. Tighten the three lamp unit
xing screws securely with a Phillips
screwdriver
Attach the lamp cover, and tighten the 5 )
lamp cover xing screw securely with
a Phillips screwdriver.
Attach the lamp cover by pushing it slowly
z
opposite the direction of the arrow.
J
Resetting the Lamp Runtime
Be sure to reset the [Lamp runtime] after replacing the lamp. (
z
Æ
page 54 " Lamp runtime reset")
Lamp cover
Lamp cover
xing screw
Handles
Lamp unit
Lamp cover xing screw
To Next Page
Loading...
