Panasonic PT-TW380

114 - ENGLISH
1) Remove the air filter cover. (Fig.1)
f Pull out the air lter cover from the hook of the projector while slightly pushing upward the tabs of the air
lter cover and open it in the direction of the arrow in gure.
2) Remove the air filter unit.
f The air lter unit is xed by the three hooks. Grasp the bre of the air lter unit near to the cover side with
one hook and then pull the air lter unit out from the air lter cover as arrow direction shown. (Fig.2)
f After removing the air lter unit, remove foreign objects and dust from the air lter compartment and the
projector’s intake vent if there are any.
Cleaning the air lter unit
Remove the air lter unit beforehand according to the previously described procedure in “Removing the air lter
unit”.
1) Clean the air filter unit.
f Vacuum dirt and dust from the air lter unit.
f Do not wash the air lter unit.
Attaching the air lter unit
1) Attach the new air filter unit to the air filter cover.
f There is a distinction between the inside and outside of the air lter unit. Align the red mark on the air lter
unit with the red mark on the air lter cover.
Air lter unit
Inside (Smooth bre)
Outside (Cotton-like bre)
Air lter cover
Red mark
f Insert the air lter unit to the side with the two hooks and then press the other side of the air lter unit into
the cover side with one hook.
Hook
Hook
Air lter cover
Air lter unit
Red mark
2) Attach the air filter cover to the projector.
f Perform Step 1) in “Removing the air lter unit” (x page 113) in the reverse order.
f Make sure that the air lter cover is closed tightly.
Resetting the filter counter
Be sure to reset the lter counter after cleaning or replacing the air lter unit.
1) Connect the power plug, press the power <v/b> button.
2) Press the <MENU> button to display the main menu, then press as to select [PROJECTOR SETUP].
3) Press the <ENTER> button, press as to select [FILTER COUNTER].
Chapter 6 Maintenance - Maintenance/replacement