[EXTRON XTP]
Make connection setting for the “XTP transmitter” of Extron Electronics.
1) Press as to select [DIGITAL LINK].
2) Press the <ENTER> button.
f The [DIGITAL LINK] screen is displayed.
3) Press as to select [EXTRON XTP].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
Select this item when connecting the optional DIGITAL LINK output supported device (Model No.:
ET-YFB100G, ET-YFB200G) to the <DIGITAL LINK/LAN> terminal.
[ON]
Select this item when connecting the “XTP transmitter” of Extron Electronics to the <DIGITAL LINK/
LAN> terminal.
Note
f For details of the “XTP transmitter”, visit the website of Extron Electronics.
URL http://www.extron.com/
[WIRED LAN]
Perform the connection settings to use wired LAN.
1) Press as to select [WIRED LAN].
2) Press the <ENTER> button.
f The [WIRED DETAILED SETUP] screen is displayed.
3) Press as to select an item, and change the setting according to the menu operation instructions.
[DHCP]
[ON]
Set when a DHCP server exists in the network to which the
projector is connected and the IP address is obtained automatically.
[OFF]
Set when a DHCP server does not exist in the network to which the
projector is connected and you need to specify the IP address.
[IP ADDRESS]
Enter the IP address when [DHCP] is set to [OFF].
[SUBNET MASK]
Enter the subnet mask when [DHCP] is set to [OFF].
[DEFAULT GATEWAY]
Enter the default gateway address when [DHCP] is set to [OFF].
[DNS1]
Enter the preferred DNS server address when [DHCP] is set to [OFF].
[DNS2]
Enter the alternate DNS server address when [DHCP] is set to [OFF].
4) After the setting, select [OK] and press the <ENTER> button.
Note
f For the setting content of each item, consult your network administrator.
f The network setting is common for the <LAN> terminal and the <DIGITAL LINK/LAN> terminal.
f Wired LAN and wireless LAN cannot be used in the same segment.
f When using the projector with [DHCP] set to [ON], conrm that the DHCP server is running.
r Factory default settings
f Following setting has been made as a factory default.
[DHCP]
[OFF]
[IP ADDRESS]
192.168.10.100
[SUBNET MASK]
255.255.255.0
[DEFAULT GATEWAY]
192.168.10.1
[DNS1] / [DNS2]
(Blank)
102 - ENGLISH
Chapter 4 Settings - [NETWORK] menu
To Next Page
Loading...
