1) Press as to select [FRAME LOCK].
2) Press qw or the <ENTER> button.
f The [FRAME LOCK] individual adjustment screen is displayed.
3) Press qw to switch the item.
f The items will switch each time you press the button.
[ON]
The frame is locked. Synchronizes the displayed image to the vertical scanning frequency of the input
signal.
[OFF]
The frame lock function is turned off. Set to [OFF] if you are concerned about ickering.
[CLAMP POSITION]
You can adjust the optimal point when the black part of the image is blunt or it has turned green.
1) Press as to select [CLAMP POSITION].
2) Press qw to adjust.
Status Rough guide for optimal value Range of adjustment
The black part is blunt.
The point where bluntness of the black part improves the
most is the optimal value.
1 ~ 255
The black part is green.
The point where the green part becomes black, and the
bluntness has improved is the optimal value.
Note
f [CLAMP POSITION] can be adjusted only when a signal is input to the <COMPUTER 1 IN> terminal or the <COMPUTER 2 IN> terminal.
f Some signals may not be adjusted.
ENGLISH - 77
Chapter 4 Settings - [POSITION] menu
To Next Page
Loading...
