Contents of mail sent
Example of E-mail sent when E-mail is set
Mail with the contents shown below is sent when the e-mail settings have been established.
=== Panasonic projector report(CONFIGURE) ===
Projector Type : PT-VX600
Serial No : SH1234567
----- E-mail setup data -----
TEMPERATURE WARNING SETUP
MINIMUM TIME at [ 60] minutes interval
INTAKE AIR TEMPERATURE Over [ 32degC / 89degF ]
ERROR [ OFF ]
LAMP RUNTIME
[ OFF ] at REMAIN [ 400] H
LAMP RUNTIME
[ OFF ] at REMAIN [ 200] H
INTAKE AIR TEMPERATURE
[ OFF ]
----- check system -----
FAN [ OK ]
INTAKE AIR TEMPERATURE
[ OK ]
EXHAUST AIR TEMPERATURE
[ OK ]
LAMP REMAIN TIME
[ OK ]
LAMP STATUS [ OK ]
APERTURE (CONTRAST-SHUTTER)
[ OK ]
AIR FILTER
[ OK ]
(Error code 00 00 00 00 00 00 00 00)
Intake air temperature : 31 degC / 87 degF
Exhaust air temperature : 37 degC / 98 degF
PROJECTOR RUNTIME 800 H
LAMP ECO 500 H
LAMP NORMAL
100 H
LAMP REMAIN
3400 H
-------- Current status ---------
MAIN VERSION 1.00
NETWORK VERSION 1.00
SUB VERSION 1.00
LAMP STATUS LAMP=ON
INPUT RGB
SIGNAL NAME XGA6
SIGNAL FREQUENCY 0.00kHz / 0.00Hz
----- Wired Network conguration -----
DHCP Client OFF
IP ad d r e ss 192.168.10.100
M AC ad d ress 04:20:9A:00:00:00
----- Memo -----
Chapter 4 Settings - [NETWORK] menu
90 -
ENGLISH