Panasonic PT-VW540

All white
The test pattern is displayed together with the operation guide of [PATTERN SELECT]. Select your
desired test pattern.
Color bar (Vertical)
Color bar (Horizontal)
Cross
Cross (Inversion)
Cross hatch
Note
f Some adjustment menus such as the [POSITION] menu → [SCREEN ADJUSTMENT] and the [DISPLAY OPTION] menu → [COLOR
ADJUSTMENT] can be set even when the test pattern is displayed.
f The setting of the [LAMP POWER] is disabled when the test pattern is displayed.
f If [TEST PATTERN] is assigned to the <FUNCTION> button on the remote control, the cross hatch pattern will be displayed after pressing
the <FUNCTION> button.
[FILTER COUNTER]
This function is used to check the usage time of the air lter or set the cleaning/replacement cycle of the air lter.
Also, you can reset the air lter usage time.
1) Press as to select [FILTER COUNTER].
2) Press the <ENTER> button.
f The [FILTER COUNTER] screen is displayed.
[FILTER COUNTER]
Displays the usage time of the air lter.
[TIMER]
Sets the cleaning/replacement cycle of the air lter.
[FILTER COUNTER RESET]
Resets the air lter usage time.
Setting [TIMER]
If you want to regularly clean/replace the air lter, set its cycle time. When the air lter usage time reaches the set
time, a message of “FILTER COUNTER has reached the set time” prompting you to clean/replace the air lter is
displayed on the projection screen.
1) Press as to select [FILTER COUNTER].
2) Press the <ENTER> button.
f The [FILTER COUNTER] screen is displayed.
3) Press as to select [TIMER].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
Select not to display the message.
[1000H] - [7000H]
Select to display the message. You can set the cleaning/replacement cycle of the air lter in
increments of 1000 hours.
Setting [FILTER COUNTER RESET]
Resets the usage time of the air lter.
1) Press as to select [FILTER COUNTER].
2) Press the <ENTER> button.
f The [FILTER COUNTER] screen is displayed.
3) Press as to select [FILTER COUNTER RESET].
4) Press the <ENTER> button.
5) When the confirmation screen is displayed, press qw to select [OK] and then press the <ENTER>
button.
f The display of [FILTER COUNTER] changes to “0H”.
84 - ENGLISH
Chapter 4 Settings - [PROJECTOR SETUP] menu