-11-
Maintenance
n Lamp unit
The lamp unit is a consumable component. You can check the total usage time using Lamp runtime in the Information
menu.
It is recommended to ask an authorized engineer to replace the lamp unit. Contact your dealer.
Consult your dealer to purchase a replacement lamp unit (ET-LAV100, dealt as a service parts).
CAUTION:
n Do not replace the lamp unit when it is hot. (Wait at least 45 minutes after use.)
The inside of the cover can become very hot, take care to avoid burn injuries.
n Notes on the replacement of the lamp unit
• The luminous source of the lamp is made of glass and may burst if
you hit it against a hard surface or drop it.
Please handle with care.
• A Phillips screwdriver is required for replacement of the lamp unit.
• When replacing the lamp unit, be sure to hold it by the handle. Hold
the lamp unit horizontally while replacing it to prevent fragments of
glass from scattering, in case the lamp breaks. When the projector
is mounted on a ceiling, do not work directly under the projector or
put your face close to the projector. Pull the old lamp unit out hori-
zontally.
• The lamp contains mercury. Consult your local municipality or your
dealer about correct disposal of used lamp units.
Attention
• Do not use other than designated lamp units.
• The part numbers of accessories and separately sold components are subject to change
without notice
n When to replace the lamp unit
When the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears on the screen
and LAMP REPLACE indicator lights yellow. Replace the lamp with a new one promptly.
On screen
Lamp replacement icon
LAMP REPLACE indicator
Over 3000 hours
The message is displayed for 10 seconds. If
you press any button within the 10 seconds,
the message disappears.
Lights in yellow (even in stand-by
mode).
Over 3200 hours
After ten minutes, the projector shuts off the
power automatically
Note
•
Allow a projector to cool enough before you open the lamp cover. The inside of the projector can become very hot.
• The Lamp replacement icon will not appear when the display function is set to Off, or during Freeze, or AV mute.
To Next Page
Loading...
