-17-
1. Cabinet top, cabinet front removal
Mechanical Disassembly
Mechanical disassembly should be made following procedures in numerical or-
der.
Following steps show the basic procedures, therefore unnecessary step may
be ignored.
Caution:
The parts and screws should be placed exactly the same position as the original
otherwise it may cause loss of performance and product safety.
Screws expression
(Type Diameter x Length) mm
T type M Type
B
RC board
Fig.1
Cabinet top
1. Pull up two latches to take off the filter cover(side).
2. Loosen 1 screw-A to remove the lamp cover.
3. Remove 6 screws-B (M3x8) and 1 screw C-(M3x8) to remove the cabinet top.
4. Remove 4 screws-D (M3x8) and 3 screws-E (T3x8) to remove the cabinet front.
Control buttons
Lamp cover
A
B
B
D
D
D
F
Dec inlay LED
Cabinet front
B
B
B
F(T3x8)x2
E
E
E
C
Filter cover(side)
Latches
D
To Next Page
Loading...
