Powering ON/OFF
24
- ENGLISH
Basic Operation
POWER indicator
The power indicator informs you the status of the power
. Conrm the status of the <POWER> indicator before
operating the projector.
Indicator status Status
No illumination or ashing The power cord is unplugged.
RED
Lit
The power cord is plugged.
The projector is in stand-by mode, after the cooling is completed.
Flashing
The projector is cooling down. The projector cannot be turned on until cooling is
completed and the <POWER> indicator stops blinking.
The temperature inside the projector is abnormally high and the projector is cooling
down. And the <WARNING> indicator also blinks in red (
Æ
page 71). The projector
cannot be turned on until cooling is completed and the <POWER> indicator stops
blinking.
GREEN
Lit Projecting.
Flashing
The projector is in stand-by status with [Power management] function.
The projection lamp will be turned on if the input signal is reconnected or any
button on the control panel or remote control is pressed. (
Æ
page 51)
To Next Page
Loading...
