Panasonic PT-VX41

Technical Information
ENGLISH -
89
Appendix
Mode
Display
resolution *
1
(dots)
Scanning
frequency
Dot clock
frequency
(MHz)
Picture
quality *
2
PnP*
3
Format
H (kHz)
V
(Hz)
D-WXGA
1 360 x 768
47.700 60.00 86.670 A
H
56.160 72.000 100.190 A
1 366 x 768
46.500 50.000 67.400 A
48.360 60.00 86.670 A
1 376 x 768 48.360 60.00 86.670 A
1 280 x 768
47.776 59.870 79.500 A
60.289 74.893 102.250 A
68.633 84.837 117.500 A
55.993 69.991 94.964 A
57.675 72.004 97.817 A
1 280 x 800
49.572 59.870 83.282 A
41.200 50.000 68.557 A
49.702 59.810 83.500 A ○
63.980 60.020 108.000 A
58.289 69.975 98.858 A
60.044 71.995 102.795 A
62.790 74.928 106.492 A
71.553 84.879 122.498 A
D-SXGA 1 280 x 1 024
63.98 60.02 108 A
60.276 58.069 93.067 A
31.65 29.8 53.48 A
D-1 035i 1 920 x 1 035i 33.75 60.00 74.25 A
D-1 080i 1 920 x 1 080i
28.125 50.00 74.25 A ○
33.75 60.00 74.25 A ○
D-1 080p 1 920 x 1 080
67.5 60.00 148.5 A
56.25 50.00 148.5 A
D-WXGA+ 1 440 x 900 55.935 59.887 106.500 A
D-WSXGA+ 1 680 x 1 050 65.290 59.954 146.250 A
D-WUXGA 1 920 x 1 200 74.038 59.950 154.000 A
“i” added to the resolution value indicates an interlaced signal.*1 :
Picture quality is indicated by the following symbols.*2 :
AA: Maximum picture quality can be obtained.
A: Signals are converted by the image processing circuit.
The signal marked with circles (O) can be applied by plug-and-play device.*3 :
Note
The number of display dots is 1 024 x 768.
z
A signal with a different resolution will be projected after converting the resolution to match the projector
display.
When interlaced signals are connected, icker may occur on the projected image.
z