Panasonic PV-GS250 - Charging Time and Recordable Time

Before using
17
LSQT0862
x Connecting to the AC outlet
1
Connect the AC cable to the AC adaptor and
the AC jack.
2 Connect the DC cable to the AC adaptor.
3 Connect the DC cable to this product.
pLift up the viewfinder beforehand.
pThe output plug of the AC cable is not
completely connected to the AC adaptor jack.
As shown in , there is a gap.
pDo not use the power cord for other
equipment since the power cord is exclusively
designed for this Camcorder. Do not use the
power cord from other equipment for this
Camcorder.
x
Fitting the battery
Push the battery against the battery holder and
slide it until it clicks.
x
Removing the battery
While pushing the [PUSH BATT] button, slide the
battery (or the DC input lead) to remove it.
pHold the battery with your hand so it does not
fall.
Charging time and recordable time
The times shown in the table below show the
times at a temperature of 68QF (25QC) and a
humidity of 60%. This is just a guide. If the
temperature is higher or lower than the specified
value, the charging time will become longer.
 Charging time
 Maximum continuously recordable time
“1h. 10 min.” indicates 1 hour 10 minutes.
pThe battery CGA-DU12 is supplied.
pThe times shown in the table are rough
estimates. The times indicate the recordable
time when the viewfinder is used. The times in
parentheses indicate the recordable time when
the LCD monitor is used.
pWe recommend the Battery Pack CGA-DU12
and CGA-DU21 for long recording time (2 hour
or more for continuous recording, 1 hour or
more for intermittent recording).
pThe recordable time will become shorter in the
following cases:
pWhen you use both the viewfinder and the
LCD monitor simultaneously while rotating
the LCD monitor frontward to record yourself,
0 Lux MagicPix function, etc.
pWhen you use this Camcorder with the LCD
monitor lit up by pressing the [POWER LCD]
button.
pWhen you use accessories fitted on the
Camcorder’s smart accessory shoe such as
the stereo zoom microphone and video DC
light, etc..
pThe batteries heat up after use or charging. The
Camcorder being used will also heat up. This is
normal.
pAlong with the reduction of the battery capacity,
the display will change: LM
NOP. If the battery
discharges, then O (P) will flash.
1
PUSH
BATT
Supplied
battery/
CGA-DU12
(7.2 V/
1150 mAh)
 2 h. 25 min.
 2 h. 5 min.
(1 h. 55 min.)
CGA-DU21
(7.2 V/
2040 mAh)
 3 h. 55 min.
 3 h. 30 min.
(3 h. 15 min.)
CGR-DU06
(7.2 V/
640 mAh)
 1 h. 40 min.
 1 h. 5 min.
(1 h.)