Record mode
30
LSQT0862
Recording still pictures onto a card
(Photoshot)
pSet to Card Recording Mode.
1 Press the [PHOTO SHOT] button halfway in
order to adjust focusing. (For auto focusing
only)
pIf you set [EIS] to [ON], then the image
stabilizer function will be more effective.
(MEGA Optical image stabilizer will be
indicated.)
pThe iris/gain value is fixed and this
Camcorder focuses on the subject
automatically.
Shutter chance mark
n (The white lamp flashes.):
Focusing
q (The green lamp lights up.):
When in focus
No mark: When focusing is unsuccessful
pThe shutter chance mark is indicated as follows
when the [PHOTO SHOT] button is not pressed
halfway. Please use it as a guide for recording.
q (The green lamp lights up.):
When in focus and a good picture
can be recorded
n (White lamp lights up.):
Almost in focus
Focus area
2 Press the [PHOTO SHOT] button fully.
x
To record still pictures clearly
pWhen zooming in on the subject with a
magnification of4M to 10M or higher, it is
difficult to reduce the slight shaking from holding
the Camcorder by hand. We recommend
decreasing the zoom magnification and
approaching the subject when recording.
pWhen recording still pictures, hold the
Camcorder firmly with your hands and keep
your arms stationary at your side so as not to
shake the Camcorder.
pYou can record stable pictures without shaking
by using a tripod and the remote control.
pFor the number of still pictures to be recorded
on a card, refer to
-80-.
pThe sound cannot be recorded.
pWhile data is being recorded on a card, do not
operate the mode dial.
pWhen the access lamp is lit, do not insert or
remove a card.
pAnother product may degrade or not play back
data recorded on this Camcorder.
pIf set [PICT. QUALITY] >> [ ], mosaic-pattern
noise may appear on a playback image
depending on the picture content.
pWhen the [PICTURE SIZE] is set to other than
[640], the mega pixel recording mode is set.
pWhen the picture size setting is other than [640],
the scene around the subject can be recorded
wider than that in [640].
x
On-screen display in the card
recording mode
1) Still picture size
2) Number of recordable still pictures
(When no pictures can be recorded, the red
light will flash.)
3) Quality of still pictures
x
Progressive Photoshot
You can record still pictures with higher picture
quality and frames. (You cannot switch the
progressive function off/on.)
pIn the tape recording mode, the progressive
function may be disabled depending on the
other functions used. (
-69-)
PC
PHOTO
SHOT
1
2
100
1)
2)
3)
To Next Page
Loading...
