5
IMPORTANT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Please Read Before Starting
Check of Density Limit
1.  GENERAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
1-1.  Tools Required for Installation (not supplied)
1-2.  Accessories Supplied with Unit
1-3.  Type of Copper Tube and Insulation Material
1-4.  Additional Materials Required for Installation
2.  SELECTING THE INSTALLATION SITE  . . . . . . . . . . . . . . 9
2-1. Indoor Unit
3.  HOW TO INSTALL THE INDOOR UNIT  . . . . . . . . . . . . . . . 9
■
  4-Way Cassette 60x60 Types
(Y1 Type) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
3-1.  Preparation for Ceiling Suspension 
3-2.  Mounting the Suspension Bolts
3-3.  Placing the Unit Inside the Ceiling 
3-4.  Installing the Drain Pipe
3-5.  Checking the Drainage
■
  Ceiling Type (T1 Type) . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
3-6.  Required Minimum Space for Installation and Service
3-7.  Suspending the Indoor Unit
3-8.  Duct for Fresh Air
3-9. Shaping the Tubing
3-10.  Installing the Drain Pipe
■
  Low Silhouette Ducted Type (F1 Type)  . . . . . . . . . . . . . . . 17
3-11.  Required Minimum Space for Installation and Service
3-12.  Suspending the Indoor Unit 
3-13.  Installing the Drain Pipe 
3-14.  Checking the Drainage 
3-15.  Installing the Air-intake Filter
3-16.  Increasing the Fan Speed
■
  Slim Low Static Ducted Type (M1 Type)  . . . . . . . . . . . . . . 22
3-17.  Required Minimum Space for Installation and Service
3-18.  Preparations Before Installation
3-19.  For Bottom Intake
3-20.  Installing the Duct
3-21.  Suspending the Indoor Unit
3-22.  Installing the Drain Pipe
3-23.  Checking the Drainage
3-24.  Increasing the Fan Speed
■
  High Static Pressure Ducted Type (E1 Type) . . . . . . . . . . . 27
3-25.  Required Minimum Space for Installation and Service 
(73, 106, 140 Types)
3-26.  Required Minimum Space for Installation and Service 
(224, 280 Types)
3-27.  Suspending the Indoor Unit
■
  RAP Valve Kit (Refrigenrant Accumulation Protector Valve 
Kit) (CZ-P160RVK2)  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29
3-28.  Installing the Refrigerant Tubing
3-29.  Installing the Drain Piping
3-30.  Caution for Ducting Work
3-31.  Increasing the Fan Speed (280 Type Only)
■
  4-Way Cassette Type (U1 Type)  . . . . . . . . . . . . . . . . . . . . 32
3-32.  Preparation for Suspending
3-33.  Suspending the Indoor Unit
3-34.  Placing the Unit Inside the Ceiling
3-35.  How to Process Tubing
3-36.  Installing the Drain Pipe
3-37.  Important Note for Wiring 4-Way Cassette Type
4.  ELECTRICAL WIRING . . . . . . . . . . . . . . . . . . . . . . . . . . . 37
4-1.  General Precautions on Wiring 
4-2.  Recommended Wire Length and Wire 
Diameter for Power Supply System 
4-3.  Wiring System Diagrams 
5.  HOW TO PROCESS TUBING   . . . . . . . . . . . . . . . . . . . . . 42
5-1.  Connecting the Refrigerant Tubing
5-2.  Connecting Tubing Between Indoor and 
Outdoor Units
5-3.  Insulating the Refrigerant Tubing
5-4. Taping the Tubes
5-5.  Finishing the Installation
6.  HOW TO  INSTALL THE TIMER  REMOTE CONTROLLER
(OPTIONAL PART) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 44
NOTE
Refer to the Operating Instructions attached to the optional 
Timer Remote Control Unit.
7. HOW TO INSTALL THE CEILING PANEL  . . . . . . . . . . . . . 44
■
  4-Way Cassette Type (U1 Type)  . . . . . . . . . . . . . . . . . . . . 44
7-1.  Preparation for Ceiling Panel Installation
7-2.  How to Install the Ceiling Panel
7-3. Others
Page 
CONTENTS
Panaindoor336013Eng.indb5Panaindoor336013Eng.indb5 2012/03/2121:06:582012/03/2121:06:58