18
RQT6850
You can record to a tape deck connected to TAPE REC (OUT) or to a
VCR connected to VCR 1 OUT.
See the recording unit’s operating instructions for details on how to
prepare it for recording.
When recording with a tape deck, you can record any source except
TAPE.
When recording with a VCR (connected to VCR 1), you can record any
source except TAPE or VCR 1.
11
Turn [INPUT SELECTOR] to select the source to be
recorded.
22
Begin recording.
Follow your recording unit’s operating instructions.
33
Start the source to be recorded.
Follow your equipment’s operating instructions.
¡ You cannot record a source connected through a digital terminal.
When recording CD, DVD, or TV, ensure the source is connected
through the corresponding analogue terminals and “ANALOG” input is
selected.
¡ When you select DVD 6CH INPUT mode, only sound from the front
left and right channels is recorded.
Note
Recording on a tape deck or VCR
Making a recording Using outdoor antennas
Preparation;
¡ Disconnect the FM indoor antenna.
¡ The antenna should be installed by a competent technician.
FM outdoor antenna
Two types of wire commonly used for connection from the antenna are
300 Ω parallel feeder wire and 75 Ω coaxial cable. For best resistance to
interference, use 75 Ω coaxial cable.
AM outdoor antenna
¡ Run a piece of vinyl wire horizontally
across a window or other convenient
location.
¡ Leave the loop antenna connected.
¡ Disconnect the antenna when the unit is
not in use. Do not use the antenna during
an electrical storm.
FM outdoor
antenna
75 Ω coaxial cable
For
continental Europe and the United Kingdom
For
other areas
10 mm
7 mm
q Remove a piece of the outer
vinyl insulator.
r Install the coaxial cable.
Clamp the cable conductor,
and wind it on so that it does
not contact anything else.
e Remove the lead wire and
clamp it with the plastic bar.
w Carefully pull the tabs apart to
remove the cover.
Lead wire
To connect a 75 Ω coaxial cable
Antenna plug
(included)
FM outdoor
antenna
300 Ω feeder wire
Plastic bar
75 Ω coaxial
cable
Clamp with
pliers
t Attach the cover.
To connect a 300 Ω feeder wire
Loosen the screws, connect the wires, and tighten the
screws to secure the connection.