Step 1 : Remove 3 screws at rear panel.
Step 2 : Remove 2 screws at DSP P.C.B..
Step 1 : Remove 1 screw at rear panel.
Step 2 : Remove 1 screw at AC In P.C.B..
Step 3 : Disconnect 4 connectors (CN906, CN904B, CN405
&CN403B) at DSP P.C.B..
Step 4 : Lift up and remove the DSP P.C.B. as the arrow
shown.
Caution:
Remember to use tie wraps to tie red/ white wires between (AC
In P.C.B. and Power P.C.B.) to the side of AC In P.C.B. after
repair or troubleshooting.
8.9. Disassembly of DSP P.C.B.
·
Follow the (Step 1) - (Step 3) of item 8.4. - Disassembly of Top Cabinet
8.10. Disassembly of AC In P.C.B.
·
Follow the (Step 1) - (Step 3) of item 8.4. - Disassembly of Top Cabinet
18
SA-HT40EE
To Next Page
Loading...
