Changing the remote
control code
Change the code if you find the remote
control unintentionally also controls other
Panasonic equipment.
Do the following to set the remote control
code and this unit’s remote control mode
to the same one.
Basic operations
Turn to select.
Press to confirm.
To return to the
previous menu/to
cancel
Change the main unit’s mode
1. Enter the SETUP menu.
Press and hold for about 2
seconds.
2. Select and press [ENTER].
3. Select and press [ENTER].
4. Press [-MENU, –SETUP, RETURN]
twice to select “EXIT” and press
[ENTER].
5. Press
6. While pressing
, press and
hold for about 2 seconds.
Change the remote control’s code
To restore the code to “1”
On the main unit: In step 3, select
“1”.
On the remote control: In step 6,
while pressing [ENTER], press and
hold [1] for about 2 seconds.
•
•
Enter a code to operate some equipment
This remote control can operate Panasonic and Technics audio-visual equipment that
have remote control sensors. You may need to change the remote control code.
It can also operate some other brands of televisions, video cassette recorders, and DVD
players. Check the table for the brand and enter the code as follows.
Changing the codes
Note that this remote control cannot operate some equipment and that it may not be
able to perform some operations.
Re-enter the codes after you change the batteries.
•
•
Code table
Enter the first digit. Enter the second digit.
The remote control outputs the on/off signal.
If the code is correct, the equipment turns on or off.
If it doesn’t, try entering another code.
To Next Page
Loading...
