12
VQT3M52
STEP 1: Preparing the speakers
Caution
≥
Do not stand on the base. Be cautious when children are near.
≥ When carrying speakers, hold the stand and base parts.
Preparation
≥ To prevent damage or scratches, lay down a soft cloth and
perform assembly on it.
≥ For wall mount, refer to page 44.
≥ Be careful not to cross (short-circuit) or reverse the polarity of the speaker wires as doing so may damage the speakers.
≥ Do not hold the speaker in one hand to avoid injury by dropping the speaker when carrying.
∫ Preventing the speakers from falling [BTT362] [BTT262]
≥Consult a qualified housing contractor concerning the appropriate procedure when attaching to a concrete wall or a surface that
may not have strong enough support. Improper attachment may result in damage to the wall or speakers.
≥Use a string of less than ‰ 2.0 mm, which is capable of supporting over 10 kg.
e.g. [BTT362] A String (not supplied)
Thread from the wall to the speaker and tie tightly.
B Rear of the speaker
C Screw eye (not supplied)
D Wall
E Approx.150 mm
[BTT362]
∏ 2 Front speakers ∏ 2 Bases
(RYK1637-K)
∏ 2 Screws A
(XTB4+12GFJK)
∏ 2 Speaker cables
(REEX1266A: RED)
(REEX1267A: WHITE)
Assembling the speakers [BTT362]
Thread the speaker cable through the base.
≥ Use cables with a white connector and red connector.
Leave about
110 mm
Insert the wire fully.
r: White
s: Blue line
Pull the cable
straight along the
line and slide into
the groove.
Tighten securely.
Press into the groove.
Push!
Back of the base
SCBTT362_262_EB_VQT3M52_eng.book 12 ページ ２０１１年１月２５日 火曜日 午後８時２２分
To Next Page