37
11.4.3. Disassembly of SMPS P.C.B.
• Refer to “Disassembly of Top Cabinet”.
Step 1 : Remove 1 screw.
Step 2 : Detach 6P Cable Wire at the connector (CN5900) on
DAMP P.C.B..
Step 3 : Detach 9P FFC at the connector (CN1) on SMPS
P. C . B . .
Step 4 : Remove 4 screws.
Step 5 : Release the guides on the right side Rear Panel
slightly.
Caution: During assembling, ensure that the Rear Panel is
seated properly onto the guide.
To Next Page
Loading...
