73
11.6.4. Replacement of Digital Amplifier IC
(IC5200)
• Refer to “Disassembly of Rear Panel Block”.
• Refer to “Disassembly of DAMP P.C.B.”.
11.6.4.1. Disassembly of Digital Amplifier
IC (IC5200)
Caution: Avoid touching the DAMP Heatsink & P.C.B. due
to its high temperature after prolonged use. Touching
is may lead to injuries
Step 1 : Remove Heatsink Clip.
Step 2 : Desolder the pins of Digital Amplifier IC (IC5200) on
the solder side of the DAMP P.C.B..
To Next Page
Loading...
