Panasonic SC-PM46 - Using the FM;AM Radio; Manual Tuning; Memory Preset Stations

RQTV0304
10
Using the FM/AM radio
Manual tuning
Manual tuning
1
Press [FM/AM] (
Southeast Asia
: [TUNER/BAND])
repeatedly to select “FM” or “AM”.
2
Press [PLAY MODE] to select “MANUAL”.
3
Press [ /4] or [ /¢] to select the frequency of the
required station.
“ ST ” is displayed when a stereo FM broadcast is being
received.
To tune automatically
Press [ /4] or [ /¢] for a moment until the frequency starts
changing rapidly. The unit begins auto tuning, stopping when it fi nds
a station.
• Auto tuning may not function when there is excessive
interference.
• To cancel auto tuning, press
[ /4] or [ /¢] once again.
To improve FM sound quality
To improve FM sound quality
Press and hold [PLAY MODE] to display “MONO”.
To cancel
Press and hold [PLAY MODE] again until “MONO” disappears.
• MONO is also cancelled if the frequency is changed.
• Turn off “MONO” for normal listening.
Memory preset
Memory preset
Up to 20 stations can be set in the FM band and 15 stations in the
AM band.
Preparation
Press [FM/AM] (
Southeast Asia
: [TUNER/BAND]) to select “FM” or
“AM”.
Automatic presetting
Automatic presetting
Press and hold [PROGRAM] to start presetting.
Manual presetting
Manual presetting
1
Press [PLAY MODE] to select “MANUAL”.
2
Press [ /4] or [ /¢] to tune to the required station.
3
Press [PROGRAM].
4
Press numeric buttons to select a channel.
The station occupying a channel is erased if another station is
preset in that channel.
5
Repeat steps 2 to 4 to preset more stations.
Selecting a preset station
Selecting a preset station
Press numeric buttons to select the channel.
For two-digit channel, press [
h 10], then the two digits.
OR
1
Press [PLAY MODE] to select “PRESET”.
2
Press [ /4] or [ /¢] to select the channel.
AM allocation setting
AM allocation setting
By main unit only
This system can also receive AM broadcasts allocated in 10 kHz
steps.
To change the step from 9 kHz to 10 kHz
1
Press and hold [AM] (
Southeast Asia
: [TUNER/BAND]).
After a few seconds the display changes to a fl ashing display of
the current minimum frequency.
2
Continue to hold down [AM] (
Southeast Asia
: [TUNER/
BAND]).
• When the minimum frequency changes, release the button.
To return to the original step, repeat the above steps.
• After the setting is changed, any previously preset frequency
will be cleared.
PM46_GN_GCS_En_new11.indd 10PM46_GN_GCS_En_new11.indd 10 1/30/08 5:15:28 PM1/30/08 5:15:28 PM