35
6.7. Pulley B, connector lower unit and others
1. Remove six screws and remove heater case unit from the
main body.
2. Next Bottom side.
3. Remove the belt with sliding it out while rotating pulley B.
4. Remove the hexagon nut (special) fixing pulley B by rotat-
ing it counterclockwise.
5. Remove the round plain washer, lock washer and pulley
B.
6. Remove U-clip and pull the connector lower unit out
toward the inner side.
Tips on assembly
• Position each "D" cut of the connector lower unit, pulley
B and lock washer.
To Next Page
Loading...
