5 Adjustment Procedure
5.1. B VOLTAGE
Item/Preparation Adjustment Procedure
1. Operate the TV set.
2. Set controls : (MARKET MODE CHK 2)
Bright ............. Minimum
Contrast ......... Minimum
Volume ............. Minimum
1. Confirm that the indicated test points for the
specified voltage:
TPA 140 : 141 ± 2V
TPA 12 : 12 ± 1.0V
TPA9:9±1V
TPA 5 & TPA 6 : 5 ± 0.5V
TPA 220 : 220 ± 15V
TPA 3 : 3.3 ± 0.2V
5.2. RF AGC
Item/Preparation Adjustment Procedure
1. Receive a colour bar pattern.
2. Set the input level to 69 (+1.2) db.
(75Ω opened)
3. Set RF AGC in CHK 2.
1. Set RF AGC Control such as to procedure a snowy picture.
2. Set RF AGC Control at the point just before the voltage at AGC :
TPA 20 begins to drop.
3. Increase the input level by 3 db and confirm that the voltage
changes.
5.3. HIGH VOLTAGE
Item/Preparation Adjustment Procedure
1. Operate the TV set.
2. Receive the crosshatch pattern.
3. Set to 0 Beam
(Screen Control : min. CONTRAST : min)
1. Connect a DC voltage meter to D850 cathode and confirm the
voltage is 141.0 ± 2.0V.
2. Connect a high voltage meter (Electrostatic Type) to an anode of
the picture tube.
3. Confirm that the high voltage is within the range of 31.0 ± 0.7V.
5.4. SUB TINT
Item/Preparation Adjustment Procedure
1. Receive a 3.58 MHz NTSC rainbow pattern
2. Connect oscilloscope to A21 pin 6.
3. Set controls:
BRT............. ...CENTER
COLOUR........CENTER
CONTRAST....MAX
NTSC TINT.....CENTER
AI................ ....OFF
1. Adjust Sub NTSC Tint so that the peak of level of waveform is
similar to Fig. 3
2. Receive the Rainbow pattern (3.58 MHz NTSC) on both of Main
and Sub pictures.
3. Adjust Sub NTSC Tint 2 so that the peak of level of 1.3 ± 0.5V
5.5. SUB CONTRAST
Item/Preparation Adjustment Procedure
1. Receive a colour bar pattern.
2. Connect an oscilloscope to TPA37 or TPL2 (G OUT).
3. Connect a short jumper to FBT pin3 or TPA 34 and TPA 5..
4. Set controls:
Picture menu ........ Dynamic Normal
AI .................... ......... off
1. Adjust Bright Colour:
a = 2.4 ± 0.2Vp-p
2. Adjust Sub Contrast Colour:
b = 2.7 ± 0.1Vp-p
8
TC-29PS70R
To Next Page
Loading...
