Panasonic TH-42PH10BK - Removal of DS-Board; Removal of HX-Board; Removal of DN-Board

6.4. Removal of DS-Board
1. Remove the HU Terminal Block.
(Refer to Removal of HU-Board)
2. Remove the Slot Block.
(Refer to Removal of Slot Block)
3. Disconnect the connector (DS14).
4. The Slot Block is turned inside out.
5. Remove 6 screws and then remove the Slot Cover.
6. Remove 6 screws and then remove DS-Board.
6.5. Removal of HX-Board
1. Remove the HU Terminal Block.
(Refer to Removal of HU-Board)
2. Remove the Slot Block.
(Refer to Removal of Slot Block)
3. Remove the DS-Board.
(Refer to Removal of DS-Board)
4. Remove 2 screws and then remove the Slot Case.
5. Remove 4 Hexagonal-Head screws and 2 screws and then
remove HX-Board.
6.6. Removal of DN-Board
1. Disconnect the connectors (DN6, DN31, DN33, DN35).
2. Remove the Flexible Cable from the connector (DN1).
3. Remove 4 screws and then remove DN-Board.
Note:
A re-setup of the destination is performed by MS mode
after DN-Board exchange.
10
TH-42PH10BK / TH-42PH10BS / TH-42PH10EK / TH-42PH10ES