Panasonic TH-42PH10BK - Removal of S1-Board; Removal of Fan

6.13.2. Removal of C2-Board
1. Remove 3 screws and then remove the AC-Inlet Block.
2. Remove the Flexible Cables from the connectors (C20,
C21).
3. Disconnect the connector (C23).
4. Remove 8 screws (
) and then remove the Flexible Cables
from the connectors (CB5, CB6, CB7, CB8).
5. Remove 4 screws (
) and then remove C2-Board.
6.14. Removal of S1-Board
1. Remove 2 screws (H) and then remove the S1-Board Block.
2. Disconnect the connector (S34).
3. Remove 1 screw (J) and then remove S1-Board.
6.15. Removal of Fan
1. Remove 4 screws and then remove the Fan Block.
2. Disconnect the Fan Relay Connectors.
3. Remove 12 screws (K) and then remove the Fans.
4. Reassemble the Fans in reverse order.
5. Stick the Cushions (Fan) around the Fan.
Note:
The Cushion of Fan is not re-usable.
Please use a new one when Fan exchange.
13
TH-42PH10BK / TH-42PH10BS / TH-42PH10EK / TH-42PH10ES