Panasonic TH-42PH10BK - 6 Disassembly; Removal of Rear Cover; Removal of HU-Board; Removal of Slot Block

6 Disassembly


 ·

 To disassemble P.C.B., wait for 1 minute after power was
off for discharge from electrolysis capacitors.


 ·


and marks indicate screw positions.
6.1. Removal of Rear Cover
1. Remove screws (×12 ,×8 ,×4 ,×5 ) and then
remove the Rear Cover.
6.2. Removal of HU-Board
1. Remove 4 screws (A) and then remove the HU Terminal
Block.
2. Remove 4 screws (B).
3. Remove 3 screws (C) and then remove HU-Board.
6.3. Removal of Slot Block
1. Disconnect the connectors (DS2, DS4, DS6, DS7, DS8,
DS15).
2. Remove the Flexible Cable from the connector (DS1).
3. Remove 4 screws and then remove the Slot Block.
9
TH-42PH10BK / TH-42PH10BS / TH-42PH10EK / TH-42PH10ES