30
Select the Signal from the “Setup” menu during RGB or PC input signal mode.
Press to select each item.
Press to adjust.
Signal
[
RGB
]
S
y
nc
Pull-in ran
g
e
H
-
Fre
q
. kHz
V
-
Fre
q
. Hz
H & V
Narrow
31.5
60.0
Clam
p
p
osition
Signal
[
PC
]
S
y
nc
Pull-in ran
g
e
H
-
Fre
q
. kHz
V
-
Fre
q
. Hz
H & V
Narrow
31.5
60.0
Clam
p
p
osition
The following operation methods are the same for both the Signal [RGB]
and Signal [PC].
SYNC
S
y
nc
H & V
S
y
nc
on VIDEO
S
y
nc
on G
Setting RGB sync signal setting:
Confirm that the input is set to RGB input (this setting is valid only for RGB input).
H&V: The H and V sync signals are input from the HD/VD (BNC)
connector.
On G: Uses a synchronized signal on the Video G signal, which is
input from the G (BNC) connector.
On VIDEO: Compatible with the scart plug (Europe)
The composite video signal input from the VIDEO input terminal
is used by dividing the sync signals.
Sets the width for different frequencies.
(This setting is the same for both Signal [RGB] and Signal [PC].)
Setting PC sync signal setting:
Confirm that the input is set to PC input (this setting is valid only for PC input).
H&V: The H and V sync signals are input from the HD/VD (BNC) connector.
ON G: Uses a synchronized signal on the Video G signal, which is input from the G (BNC) connector.
Pull-in range
Pull-in ran
g
e
Wide
Pull-in ran
g
e
Narrow
Displays the H (horizontal)/V ( vertical) frequencies.
This display is valid only for RGB input and PC input.
Display range:
Horizontal 15.5 - 110 kHz
Vertical 48 - 120 Hz
H-Freq. (kHz)/V-Freq. (Hz)
H
-
Freq. kHz
V
-
Freq. Hz
31.5
60.0
Setup for input signals
Clamp position
Signal
[
Component
]
Clam
p
p
osition
Adjusts the clamp position.
The following operation methods are the same for “Signal” menu during
Component (TH-42PWD3 only), RGB and PC input signal mode.
Normally, these adjustments are set to appropriate levels and therefore do not
need to be altered.
(TH-42PWD3 only)
Clam
p
p
osition
To Next Page
Loading...
Need help?
General