English
48
[DIGITAL LINK power management] (LF80 series)
When this function is set to [On], it operates under
he following conditions to turn the power on or off
automatically.
When no pictures (sync signal) are detected for
60 or so seconds at DIGITAL LINK input:
Power is turned off (standby); the power indicator
lights up orange.
When pictures (sync signal) are subsequently
detected:
Power is turned on; the power indicator lights up
green.
[DVI-D power management]
When this function is set to [On], it operates under
he following conditions to turn the power on or off
automatically.
When no pictures (sync signal) are detected for
60 or so seconds at DVI-D input:
Power is turned off (standby); the power indicator
lights up orange.
When pictures (sync signal) are subsequently
detected:
Power is turned on; the power indicator lights up
green.
[PC power management] (DPMS function)
When this function is set to [On], it operates under
he following conditions to turn the power on or off
automatically.
When no pictures (HD/VD sync signals) are
detected for 60 or so seconds at PC input:
Power is turned off (standby); the power indicator
lights up orange.
When pictures (HD/VD sync signals) are
subsequently detected:
Power is turned on; the power indicator lights up
green.
Note
●
This function is effective when [Sync] in [Signal]
is set to [Auto] or [HV sync] and during normal
viewing and [Component/RGB-in select] is set to
[RGB]. (see page 44)
[Power save]
This function adjusts the brightness of the backlight to
reduce power consumption.
[Off]:
This function does not operate.
[On]:
Backlight brightness is reduced.
Note
●
If [Input search] is set to items other than [Off], the
[Input search] function is prioritised. (The “Power
management” function does not operate for each
terminal.) (For details of [Input search] function,
see page 59.)
●
If [Failover/Failback] is set to items other than [Off],
the [Failover/Failback] function is prioritised. (The
“Power management” function does not operate for
each terminal.) (For details of [Failover/Failback]
function, see page 60.)
To Next Page