10
3 4 5 6 7 8 9
1
AC IN
Connect the supplied power cord to the wall outlet.
2
MAIN POWER SWITCH
Press to switch the main power on/off.
3
Reserved for the wired connection of the IR control.
NOTE: If an optional IR receiver is connected to [IR
TRANSMITTER IN], this Display’s remote control
sensor will stop working.
4
RS232C network input/output connection for the use of
loop-through function.
5
LAN
LAN control function for the use of remote control signal
from control center.
6
HDMI AV IN
Input the HDMI source of an AV device, or the DVI-D
output of a PC by using a DVI-HDMI cable.
7
Digital video input and output connection.
8
PC IN
Input the PC source.
9
AUDIO IN 1
Input the PC audio source (3.5 mm stereo phone jack).
10
Input the component YPbPr source from external AV
device.
For VIDEO input, connect with CVBS cable from the video
output of your AV device to this Display’s Y input (an after-
market BNC-RCA adapter will be needed).
11
Input the audio source from external AV device.
12
Output the audio source connected from the AUDIO IN
jack to an external AV device.
13
Output the audio to your external speakers.
To Next Page
Loading...
